Wenglor weCat3D MLSL, Руководство по эксплуатации

Страница: 63 / 71

63 2D/3D Profile Sensors
8.12 Password
Password protection prevents inadvertent changes to selected settings.
Password Activating the password function
Enable/Disable
Change
3
Back
7
Run
Enable/
Disable:
Change:
Enable or disable password protection. When password
protection is enabled, the sensor is automatically disabled after
pressing any key in the “Run” mode.
Change the password.
NOTE!
• If the password function has been activated, the password must be entered each time
supply power is interrupted. After pressing any key, the menu is automatically switched
to the password entry mode.
• After the password has been correctly entered, the entire menu is enabled and the
sensor can be operated. The password function is deactivated upon shipment from the
factory.
Passwords can be selected within a range of
0000 to 9999.
• It must be assured that the selected password is noted before any changes occur.
If the password is forgotten, it has to be overwritten with a master password.
The master password can be requested by e-mail from
support@wenglor.com .