Wenglor weCat3D MLSL, Руководство по эксплуатации

Страница: 39 / 71

39 2D/3D Profile Sensors
6.4.4 Adjusting the Sensor’s Network Settings
Upon shipment from the factory, the sensor’s IP address is 192.168.100.1 and its subnet mask is
255.255.255.0.
In order to be able to connect the sensor to your PC, you have to make sure that the sensor and your PC are
both within the same IP address range.
Address Format for IP Addresses (IPv4)
Network Part Device Part (host part)
IP address 192.168.100.
001
Subnet mask 255.255.255.
000
The network part of the sensor’s IP address must coincide with the network part of PC’s IP address, but the
device part of the address must be different for the sensor and the PC.
The integrated web server can then be accessed where, amongst other things, the IP address can be
changed. Further information can be found in section
7.
Alternatively, the IP address can be changed without connection to the PC directly at the control panel (OLED
display). Further information can be found in section
8.