16
EN
7.9. Reset
All Sensor settings, with the exception of the network settings, can be reset to the default settings in the menu
item "Reset. The settings of the default settings can be found in Chapter “6.2. Default Settings” on page 9.
Reset
Reset to the default settings
Press <R> for Reset
The Sensor settings that have been made can be reset to the default settings by
pressing the “R” button.
7.10. Password
Password protection prevents against changing the set data unintentionally.
Password
Set password functionality
Activate
Change
Block
3
Back
7
Run
Enable:
Turn password protection on or off. If password protection is acti-
vated, the operation of the Sensor is disabled after supply power
has been interrupted and is only enabled after successfully entering
password.
Change:
Change password.
Lock:
Locking Sensor causes an immediate disabling of operation if activate
Password is set to “on”.
If the password functionality is activated, the password must be entered before each operation of the Sensor.
After correctly entering the password by means of the “+” and “–” button, the menu is activated and the Sen-
sor is operational.
• The password functionality is deactivated in the default settings.
• The value range of the password number ranges from 0000…9999
It is necessary to note the newly defined code before changing the password. A forgotten password can
only be overwritten by a general password. The general password can be requested by sending an e-mail to
.
