Welltech Technology Co., Ltd.
56
Next/Prev
Click the Next/Prev to Next/Previous Page. The system will
auto display the Next or Previous Information.
Example 1: Set up external FXO gateway as SIP Trunk.
Click
Add/Modify
. The screen appears as shown below.
Figure 3.2.5-2 Trunk Setting
The following table describes features in this screen.
Table 3.2.5-2 Trunk Setting
Label
Description
Trunk Number
Assign the number of Trunk. This number is also used as the
register name for Trunk device.
Note: The Trunk Number can also be a “Trunk ID”. In the
Routing Table page, you should define the destination of prefix
route. When you define the prefix route, you should set up the
Trunk ID (Trunk Number) in the Trunk page first; then you
could enter the correct Trunk ID in the Destination field.
Password
Assign the register password for device to register on ePBX40.
Host
Set up the Host to
Dynamic
require the SIP trunk device to
register ePBX40 so that the ePBX40 know how to reach the
trunk. You can also set up the Host to an
IP address or FQDN
(domain name) if you set up the Host to [Pre-define]
.
There is a field
[Address]
appeared when you choose Host to
