Weller WD 1000, Руководство по эксплуатации

Страница: 31 / 55

WD 1 (M) / WD 1000 15-16
DE
EN
FR
IT
ES
PT
NL
SV
DK
FI
GR
TR
CZ
PL
HU
SK
SL
EE
LV
LT
6. Press button II (Set) to confirm the value.
The temperature deviation is now reset to 0. Calibration at
450 °C / 842 °F is now concluded.
7. Exit Menu 2 with button III.
Resetting calibration to factory settings
1. Select the menu item FCC in Menu 2.
2. Press and hold button III.
3. Then press the UP and DOWN buttons simultaneously.
"FSE“ (Factory Setting Enabled) appears in the display.
The soldering station is now reset to the factory settings.
4. Press the I (back) or II (forwards) button to switch to the next
menu item.
Setting the control characteristics for the WP 120
The HI / LO CONTROL function can be used to set the control
characteristic of the WP 120, which was set to HI in the factory:
1. Select the menu item HI / LO in Menu 2.
2. Set the status by pressing the UP (HI) or DOWN (LO) button.
8 Resetting to factory settings
Resetting the special functions
This function is described under "7.1 Selecting special functions
menu 1", "Resetting the special functions to the factory settings" on
page 8.
Resetting calibration to factory settings
This function is described under "7.2 Selecting special functions
menu 2", "Resetting calibration to factory settings" on page 12.
9 WD 1 (M) / WD 1000 care and
maintenance
Dirt and foreign objects accumulated in the join between the heating
element / sensor and the soldering tip or damage to this join may
affect the accuracy of the temperature control.
10 Fault messages and fault elimination
Message/Symptom Possible cause Corrective measures
Display: "- - -“

Tool has not been detected
 Tool defective

Check connection of tool to
device

Check connected tool
Display: "tip" Soldering tip of microtool not
correctly inserted or defective
 Insert soldering tip again

Replacing defective soldering tip
No display function (display off) No mains supply voltage
 Turn on mains power switch

Check mains supply voltage
 Check device fuse