Well 3195IF, Руководство пользователя

Страница: 59 / 62

3195IF -VoIP User Manual V1.0
53
Ex
（
<config-mmifilter>#no entry –start 202.112.20.1
[no] entry - <command>Set IP filter table
modifyfilter - <command> modify mmifilter table
show - <command>Show IP filter table
[no] start-filter - <command>Enable/Disable MMI IP filter
NAT
Path
（
<config-nat>#
[no] ftpalg - <command>Set NAT FTP application level
gateway
[no] ipsecalg - <command>Set NAT IpSec application level
gateway
[no] pptpalg - <command>Set NAT Pptp application level
gateway
show - <command>Show current NAT state
[no] tcp-entry - <command>Set NAT TCP map table
[no] udp-entry - <command>Set NAT UDP map table
Add TCP tcp-entry–ip x.x.x.x–lanport xxx–wanport xxx
Ex
（
<config-nat>#tcp-entry –ip 192.168.1.5 –lanport 1720 –wanport
1000
Del TCP ---no entry –ip x.x.x.x –lanport xxx –wanport xxx
Ex
（
<config-nat>#no tcp-entry –ip 192.168.1.5 –lanport 5060 –
wanport 1000
Add UDP ---udp–entry–ip x.x.x.x –lanport xxx –wanport xxx
Del UDP ---no udp–entry –ip x.x.x.x –lanport xxx –wanport xxx
Check NAT ---show
Port configuration
While input PORT under terminal config, the configuration will valid
to all ports, if input as PORT X, valid only to port X. Some parameter
only valid to some port, then PORT X is needed, otherwise, error
report as “Error: Missing parameter”.
Path: <config–port>#
[no] accept-relay - <command>Set accept relay mode
[no] calltransfer - <command>Enable/Disable call transfer