11
© Well Straler all rights reserved
4
Transport and storage
The appliance is packaged for shipment in a solid cardboard box and secured using PU
foam, to avoid damage during transport. Always transport the appliance upright and do not
stack anything on top of the appliance.
Upon receipt of the appliance and after removing the top part of the packaging, the
appliance should be checked for transport damage. If storing the appliance for a long
period, it should be kept in a dry place at a temperature b 5 °C and + 40 °C and
protected from the weather.
5
Installation
Local standards apply to the discharge of flue gas. An approved professional fitter must
install the appliance, or a competent inspection body must approve the installation.
◼
The installation must comply with common standards
◼
The slightest deviation exempts Well Straler from all liability in respect of the
safety and the proper functioning of the appliance
◼
Any changes to the control devices by unauthorised persons shall void the
warranty
◼
Before installation, check that the on-site distribution conditions, the type of gas,
and the pressure correspond with the settings of the appliance.
All replaceable parts must remain accessible. The appliance must be installed in such
a way that it can be removed without breakages.
The appliance must be installed in an adequately ventilated room, and the minimum
distances should always be adhered to.
If the appliance is installed against a non-heat-resistant wall, or on a non-heat-
resistant floor, an extra protective plate is required behind or underneath the appliance.