3
1.
Introduction
1.1.
Welcome
Thank you for buying your Well Straler gas heater! We are glad to have you as a customer. With this quality product
you will enjoy the cozy warmth and unique flame dance for many years.
Before using the heater, please read the instructions carefully and keep them in a safe place.
Installation must be carried out by a suitably qualified gas technician in accordance with the gas safety regulations
that are currently in effect. Make sure that you get informed by your technician about how to use, operate and
maintain your appliance. Every appliance has been tested, carefully adjusted and sealed in the factory in accordance
with I2+ or I3P category. The warranty will only be valid if the service has been completed by a competent person
(according the gas safety regulations in force). Failure to install the fire correctly could lead to prosecution.
The appliance is covered with a heat-resistant surface coating. During the first few hours of use, it is absolutely
normal that a harmless temporary odor is produced. This disappears after a short period. We advise you to let the
appliance work for a few hours in a well ventilated room.
1.2.
Warranty
This product has a 2 year warranty counting from the date of installation, and this for manufacturing defects only.
The warranty is limited to a simple exchange of parts that are recognized as defective by our technical department
and not giving cause by any means to further liability. Shipping costs and labor are not part of the warranty and
have to be paid by the user. Warranty will be invalidated if the appliance has been poorly maintained, used in a
wrong way, has been damaged in an accident or catastrophe of which the origin has no connection with the
appliance itself, or if service has been done by an unauthorized person. Delicate parts in contact with fire like glass
etc. are not covered by warranty. Complaints are only accepted when made through a recognized dealer.
1.3.
Security
1.3.1.
Built-in safeties in the control system
The system operates on radio frequency signals that are sent by the transmitter (remote) to the receiver in the
appliance. We recommend that the transmitter always be located within the operating range (± 6 m) of the
receiver.
Install the remote in vertical position (use the delivered holder) in order to get better communication.
To avoid unpleasant situations, the system has several built-in safety measures that alert the user when action is
needed.
1.3.2.
Communication safety – transmitter/receiver
The transmitter has a communication safety function built into its software. It provides an extra margin of safety
when the appliance is in the
THERMO
or
PROGRAM
mode.
The communication safety is activated when the transmitter is moved beyond the maximum recommended
operating area, which is ± 6 m. It is also activated when batteries become weak or are removed from the
transmitter. The communication safety operates in the following manner (only in
THERMO
or
PROGRAM
mode):
The room temperature is measured every 2 minutes by the transmitter and compared to the
SET
temperature. In
the same time, the transmitter sends an RF signal to the receiver, signaling that the transmitter is still in the
operating area. Should the receiver NOT receive a transmitter signal within the 5 minutes, it means that the receiver
is out of reach and no more able to transmit orders. The red led of the receiver will start blinking (0.5 second on, 0,5
second off) and the system will switch to the temperature sensor of the receiver. The fire will continue working in
the operating mode in which he stood for the disappearance of the RF-signal.
Besides, the symbol of antenna will slowly blink on the display of the transmitter. When the receiver will come
again within reach, the fault led will extinguish, the symbol of antenna will disappear and the temperature will be
controlled again by the transmitter
