Exclusively distributed by
If you have any questions or comments,
contact us on:
02 9899 8833 or
email [email protected]
PO Box 6388
Baulkham Hills, NSW, 2153
4. Push the front and back parts of the push button casing
together, taking care to position the rubber seal around the edge
of the casing.
5. Using the included double-sided tape, affix the push button to
a suitable surface. Avoid locating the push button on or directly
near metallic surfaces as this may reduce the operating range.
6: Remove the battery cover of the door chime
(located on the rear of the unit).
7: Insert 3 x ‘AAA’ Batteries (not supplied), ensur-
ing that the positive and negative markings on the
battery are correctly aligned with the positive and
negative markings on the door chime. Note that only
alkaline batteries are recommended for use with this
chime.
8: Replace the battery cover.
9: If necessary, select a melody and set the volume as per the
instructions on the next page.
10: Position the door chime as needed within the range of the
push button. Note that the door chime unit is for indoor use
only. Avoid locating the door chime on or directly near metallic
surfaces as this may reduce the operating range.
Portable Wireless Chime Kit
WC8181
Components:
1: Push Button
2: Bell Push Battery
3: Portable Chime
4: LED Light
5: Speaker
6: Musical Tone selector
7: Volume control
8: Chime Batteries
1
2
8
5
3
7
6
Setup Instructions:
1: Insert a small flat screwdriver into the
slot on the base of the push button.
2: Gently twist the screwdriver to sepa-
rate the front and back parts of the push
button casing.
3: Remove the black plastic tab from
the battery compartment and ensure
that the battery is securely in position.
www.welcomechimes.com.au
14/03/13
N95
