Welch Allyn Propaq LT 802LT0N, Руководство по обслуживанию

Страница: 58 / 80

54 Disassembly and reassembly Welch Allyn Propaq LT Vital Signs Monitor
2. Remove the two latch springs by compressing them and lifting them off of the posts.
REASSEMBLY: Note the small alignment slot on one side of the bracket and the small
alignment hole on the other.
3. Remove the latch from the upper housing.
Reassembly: Install the blue button cap on the latch. Orient the flat side of the cap toward
the catch.
Note Interconnect boards shipped in early-production cradles included a photosensor
assembly that is no longer used. Later Interconnect boards do not have the
photosensor assembly.
• If you are reusing the original interconnect board, leave the reflective foil
intact; otherwise, disregard the reflective foil.
• If you are replacing the latch, the replacement latch on the replacement board
might not look like the original.
Foil reflector used for some early-production cradles with
photosensor. (See the notes on this page and the previous page.)
Latch catch
The flat side of the blue cap is on the same side as the latch catch.