Vaginal Speculum
Storage Dispenser
Model # 58014
Mounting Instructions
Vaginal Speculum
Storage Dispenser
Model # 58014
Mounting Instructions
The storage dispenser comes with four rubber, non-skid feet mounted to the bottom surface. You can
place the storage dispenser on a countertop or, if desired, follow the directions below to mount it to
a wall.
Affixing the Storage Dispenser to wallboard:
Tools required: Phillips Screwdriver, Wall Anchors/Screws (provided), Pencil
1.
Locate the desired wall location for the storage unit and verify there are no wall studs behind
the wallboard. Hold the dispenser on the wall and use the pencil to mark the hole location on
the wall for the bottom screw at the top of the bottom screw slot. Set the dispenser aside.
2.
Drive a wall anchor into the marked hole location on the wall until it is fully seated. Then drive
a screw into the wall anchor until the screw head is approximately 1
⁄
8” (3mm) from the wall.
See Figure 2.
3.
Fit the round key hole in the bottom the system over the screw head on the wall and push
down.
4.
Level the storage dispenser and, using a pencil, mark the two top hole slots. Remove the
dispenser from the wall and secure a wall anchor completely into the wall at each marking.
5.
Replace the storage dispenser on the bottom screw. Place a screw through the top, left
dispenser hole slot and secure it into the wall anchor. Do not overtighten! Repeat for the right
side.
6.
Place one of the enclosed sizing stickers on the front of the dispenser and fill with appropriate
size specula.
1/8” / 3 mm
Figure 2
Storage Dispenser Top Hole Slots
Storage Dispenser Bottom Key Hole Slot
Figure 1
The storage dispenser comes with four rubber, non-skid feet mounted to the bottom surface. You can
place the storage dispenser on a countertop or, if desired, follow the directions below to mount it to
a wall.
Affixing the Storage Dispenser to wallboard:
Tools required: Phillips Screwdriver, Wall Anchors/Screws (provided), Pencil
1.
Locate the desired wall location for the storage unit and verify there are no wall studs behind
the wallboard. Hold the dispenser on the wall and use the pencil to mark the hole location on
the wall for the bottom screw at the top of the bottom screw slot. Set the dispenser aside.
2.
Drive a wall anchor into the marked hole location on the wall until it is fully seated. Then drive
a screw into the wall anchor until the screw head is approximately 1
⁄
8” (3mm) from the wall.
See Figure 2.
3.
Fit the round key hole in the bottom the system over the screw head on the wall and push
down.
4.
Level the storage dispenser and, using a pencil, mark the two top hole slots. Remove the
dispenser from the wall and secure a wall anchor completely into the wall at each marking.
5.
Replace the storage dispenser on the bottom screw. Place a screw through the top, left
dispenser hole slot and secure it into the wall anchor. Do not overtighten! Repeat for the right
side.
6.
Place one of the enclosed sizing stickers on the front of the dispenser and fill with appropriate
size specula.
1/8” / 3 mm
Figure 2
Storage Dispenser Top Hole Slots
Storage Dispenser Bottom Key Hole Slot
Figure 1
