Welbilt Convotherm OES mini easyTouch, Руководство по установке

Страница: 52 / 106

5.7 Setting up the appliance on a stand
Rules for setting up the appliance safely
Observe the following rules to ensure that the appliance is installed in a stable situation:
■
The stand for the appliance must be fixed so that it cannot tip over when subject to a one-sided
load - e.g. appliance door is open.
■
It must be possible to set up the stand in the installation position so that it cannot tip over or slide
about. The subfloor must satisfy relevant requirements.
The following rules must be observed to meet hygiene standards:
■
For stands that contain shelf levels for food containers, the top cover must be fitted on the stand to
prevent dirt getting onto any food held temporarily in the stand.
Installing appliance on stand with wall bracket
When setting up the appliance on a stand, follow the steps below:
Step Action Illustration
1
Position the appliance on the stand
4 3
2
1
2
Ensure the stand is horizontal by adjusting the height of
the feet (1).
Use a spirit level to ensure the unit is horizontal in all di‐
rections.
3
Locate the appliance feet in the receptacles on the
stand (2).
4
Screw the appliance onto the stand using the screws
supplied (3).
5
Use the wall bracket (4) to fix the stand and the appli‐
ance so that they cannot tip over.
Installing appliance on stand with floor attachment
If it not possible to fix the stand to the wall, the stand can be ordered from the manufacturer with a
floor attachment instead.
Observe local regulations on the floor condition for this purpose.
The following diagram shows the floor attachment part:
5 Setting up the appliance
Installation manual 52