2. Safety
Page 10
106082
– MRF-M2 -E - V0.7 - 23.04.2021
2.
Safety
2.1 General Information
The plant engineering company, the installer or the service engineer
must prepare operating instructions for the operator, taking account of
the controller's parameters as supplied.
We recommend referring only to the parameters which the end user
needs for safe operation.
In preparing the operating instructions for the end user, especially the
chapter on “Safety”, account must be taken of local regulations.
IMPORTANT NOTE
The parameter settings of the MRF-M2 as supplied do not correspond
to the intended use. This can lead to undefined behaviour by individual
components when the system is commissioned.
The general principle is that the plant constructor is responsible for
putting the regulator into operation.
These operating instructions contain important technical and safety
information. Please read carefully before installation and before any
work on or with the regulator.
It is the duty of the party commissioning the system to ensure
compliance with the following guidelines.
The regulator may only be installed by an authorised electro specialist,
observing all local safety requirements.
Access to the environment when connected must be restricted to
specialised personnel.
The regulator contain live components. They must be built into the
plant in such a way that contact with such live components is
impossible.
The regulator is not suitable for use in explosive atmospheres. Danger
of explosion. Use only outside areas subject to explosive atmospheres.
The regulator must not be used if the housing or connection terminals
are damaged.
No fluids must penetrate the housing.
The regulator may not be exported to the USA without the
manufacturer's express permission!
WARNING
WARNING
