Page of 11
9
CAUTION:
Do not use cleaning agents to clean the plastic parts of the tool. A mild detergent on a
damp cloth is recommended. Water must never come into contact with the tool.
•
Repairs
1. Only an authorized Electrician or service technician should replace the cord set or make
other repairs. If the cord set is damaged or worn, have it repaired or replaced by an
authorized Electrician or service technician.
2. When the brushes are worn, the tool may not work. Have new brushes fitted by an
authorized Electrician or service technician.
Carbon brushes
When the carbon brushes wear out the tool will spark and/or stop.
Discontinue use as soon as this happens. They should be
replaced prior to recommencing use of the tool. Carbon brushes
are a wearing component of the tool therefore not covered under
warranty. Continuing to use the tool when carbon brushes need to
be replaced may cause permanent damage to the tool. Carbon
brushes will wear out after many uses but when the carbon
brushes need to be replaced take the tool to an electrician or a
power tool repairer for a quick and low cost replacement. Always
replace both carbon brushes at the same time.