Page of 8
4
•
Never use a parts washer
with a malfunctioning switch.
Any parts washer that cannot be
controlled with the switch is dangerous and must be repaired by an authorized service
representative before using.
•
Disconnect power
from parts washer and place the switch in the locked or off position before
servicing, adjusting, installing accessories or attachments, or storing. Such preventive safety
measures reduce the risk of starting the parts washer accidentally.
•
Store idle parts washers.
When parts washer is not in use, store it in a dry, secure place out of
the reach of children. Inspect parts washer for good working condition prior to storage and
before re-use.
•
Use only accessories that are recommended
by the manufacturer for your model.
Accessories that may be suitable for one parts washer may create a risk of injury when used on
another parts washer.
•
Keep guards in place
and in working order.
•
Never leave parts washer
running unattended.
POWER SOURCE CONNECTION
POWER REQUIREMENTS
This product is designed to operate on a properly grounded 120 Volt, 60Hz, single-phase alternating
current (AC) power source fused with a 20 Amp time-delayed fuse or circuit breaker. It is
recommended that a qualified electrician verify the
ACTUAL VOLTAGE
at the receptacle into which
the product will be plugged and confirm that the receptacle is properly fused and grounded.
DO NOT OPERATE THIS PRODUCT
if the
ACTUAL
power source voltage is less than 105 Volts
AC or greater than 132 Volts AC. Contact a qualified electrician if this problem exists. Improper
performance and/or damage to the product will result if operated on inadequate or excessive power.
CONNECT TO POWER SOURCE
WARNING
High voltage danger from power source!
Consult a qualified electrician for proper installation of receptacle at the power source.
This product must be grounded while in use to protect the operator from electrical shock. If you are
not sure if your outlet is properly grounded, have it checked by a qualified electrician. Do not cut off
the grounding prong or alter the plug in any way and do not use any adapters between the product’s
power cord and the power source receptacle. Make sure the POWER switch is OFF then connect
the power cord to a properly grounded 120V AC, 60Hz, single phase, 20 Amp power source.
EXTENSION CORDS
For optimum performance, an extension cord should not be used unless absolutely necessary. If
necessary, care must be taken in selecting an extension cord appropriate for use with your specific
product.
Select a properly grounded extension cord that will mate directly with the power source receptacle
and the power cord without the use of adapters. Make certain that the extension is properly wired
and in good electrical condition.
Extension cords must be a #12-gauge cord at the smallest. Do not use an extension cord over 25 ft.
in length.
