Weir SPM Flow Line, Руководство по установке

Страница: 29 / 42

29
1. Install SPM
®
FSRs for swivel assemblies as described earlier
in this Instruction Guide, except there are no Anchor Crossover
Assemblies in this case. The set up is shown in Figure 2.
a. The swivel assemblies should have SPM
®
FSR Ribs
installed at all wing union connections, and around
unsecured swivel joint connections (any ball race
location).
b. One SPM
®
FSR spine must link all ribs.
Figure 2. SPM
®
FSR Installation on Double Swivel Assemblies
(without Anchor Crossovers)
2. As shown in Figure 3, install two additional Spines on the double
swivel assemblies in place of Anchor Crossovers. Note the main
Spine and Ribs described in step 2 are not shown here for clarity
purposes.
a. Loop one of the spines around the straight pipe in the area
that is located immediate after the swivel assemblies.
b. Loop another spine around the straight pipe in the area
that is located immediately after the other end of the swivel
assemblies.
c. Connect these two spines with an Anchor type (or “C-type”)
shackle.
One SPM
®
FSR spine links all swivel
components and goes through all ribs as shown
Ribs installed at the wing union and
swivel race locations