Weir SPM Flow Line, Руководство по установке

Страница: 11 / 42

11
INSPECTING SPM
®
FSR COMPONENTS:
Inspect each component before every use. Also, to ensure safety,
qualified personnel should inspect the complete installation before
every use.
a) SPM
®
Safety Restraints (Spines & Ribs) –
The SPM
®
FSR Spines and Ribs are designed so failures are
normally visible. If there are any signs of damage, the affected
components should be replaced. Remove SPM
®
Safety Restraints
from service if inspection indicates the following damage:
1) Any damage to the SPM
®
FSR cover where internal red-
striped white core yarns are exposed.
(This includes cuts, holes, tears, snags, abrasions or other
damage to cover).
2) The SPM
®
Safety Restraint ID tag is missing or has become
illegible.
3) Knots or other modifications to any part of the SPM
®
FSR.
4) Melting, charring, or other indications of excessive heat to
any part of the SPM
®
FSR.
5) Acid, caustic burns or other signs of chemical deterioration
to the SPM
®
FSR.
6) Any SPM
®
FSR that has been stretched beyond its original
design length, deformed, or otherwise misshapen, is
visually noticeable by the outer cover being frayed and
discolored.
7) Any other visible damage which causes doubt as to the
strength of the SPM
®
FSR.
Note: Upon removal, note the serial number for your records, cut
the restraint in half, remove the tag, and discard.