上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
41
/
53
3.3
Adjust the WCS
In programming, programmers select a certain given point on workpiece as origin
(also called program origin) to establish a new coordinate system (i.e. workpiece
coordinate system (WCS)). This operation is used to adjust the WCS.
To adjust the WCS, do the following:
1.
To enter into
Coor Manager
interface, in
Auto
mode, press
→
1
:
2.
Optional:
Parameter
N62023 Ignore Coordinate System Instruction
(G code files) or
N65212 Ignore Coordinate System Instruction
(ENG files) decides whether
the system automatically reads the WCS command in G code / ENG files:
–
When it is set to
Yes
, this step is required, because the system ignores
the WCS commands in G code / ENG files.
–
When it is set to
No
(default setting), you can skip the step, because the
system automatically reads the WCS command in G code / ENG files.
3.
