上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
25
/
53
In this interface, you can also do the following:
•
To simulate hardware signal, press
F1
to conduct a simulation test or
F2
to
close a simulation test.
The sign
T
shows next to the port, which means the port is under test.
•
To cancel all simulation tests and signals, press
F3
.
•
To set the filter time, press
F5
.
The system rules out interference signals whose occurrence time is shorter
than the set filter time.
•
To monitor the target port, press
F6
.
The system adds the port to the diagnosis list in
Diagnosis
interface.
•
To display all I/O ports, including ports not used and defined, press
F7
.
You can press
F7
again to hide them again.
•
To share port
Reference Point
,
Positive Limit
and
Negative Limit
, press
→
F2
.
Ports with the same port address share a port.
2.3
Set Commissioning Parameters
This operation is used to set parameters for commissioning, to avoid damage to the
machine tool during its movement.
According to the type of control system, it can be divided into the following:
•
Set commissioning parameters for bus control system.
•
Set commissioning parameters for non-bus control system.
To set the type of control system, press
→
1
→
F4
→
F8
, input the
manufacturer password, and modify the value of parameter
N50000 Control
System Type
.
2.3.1
Set Commissioning Parameters for Bus Control System
Before setting commissioning parameters for bus control system, ensure the
following:
•
Parameter
N50000 Control System Type
is set to
1
.
•
The used terminal board is
Lambda 5M
.
