7. Press a 1Ó Square Inner Cap (98) into the small tube
on the Press Upright (2).
Place the bracket on the lower end of the Press
Upright (2) over the indicated 5/16Ó x 2 1/2Ó Carriage
Bolts (92) in the Press Base (6). Hand tighten two
5/16Ó Nylon Locknuts (64) onto the Bolts.
Do not
tighten the Nylon Locknuts yet.
Place the bracket on the lower end of the Support
Frame (3) over the indicated 3/8Ó x 2 1/2Ó Carriage
Bolt (101) and the 3/8Ó x 4Ó Carriage Bolt (102) in the
Press Base (6). Hand tighten a 3/8Ó Nylon Jamnut
(63) onto the 3/8Ó x 2 1/2Ó Carriage Bolt (101).
Do not
tighten the Nylon Jamnut yet.
Note: Do not thread a Jamnut onto the 3/8Ó x 4Ó
Carriage Bolt (102) yet.
Attach the Support Frame (3) to the Press Upright (2)
with two 5/16Ó x 2 1/2Ó Carriage Bolts (92) and two
5/16Ó Nylon Locknuts (64).
Do not tighten the Nylon
Locknuts yet.
7
7
6.
Press a 2Ó Square Inner Cap (28) into the top of the
Front Leg (20). Press a 2Ó Square Inner Cap (28) into
each end of the Small Leg Lever (41).
Attach the Bumper (40) to the indicated hole in the
Front Leg (20) with a 1Ó Tap Screw (80).
Lubricate the 3/8Ó x 3 1/4Ó Bolt (62). Attach the Small
Leg Lever (41) to the bracket on the Front Leg (20)
with the Bolt and a 3/8Ó Nylon Jamnut (63).
Do not
overtighten the Nylon Jamnut; it must be easy to
pivot the Leg Lever.
6
92
101
102
6
92
28
28
28
41
40
80
2
63
64
3
64
64
98
63
62
Lubricate
20
8.
Press a 2Ó Square Inner Cap (28) into the Press Top
Frame (9).
Attach the Press Top Frame (9) to the indicated
bracket at the top of the Press Upright (2) with two
5/16Ó x 2 3/4Ó Bolts (89), a Support Plate with 3 1/2Ó
center holes (93), and two 5/16Ó Nylon Locknuts (64).
8
93
64
9
89
28
2
