8�3
Disconnection
Î
After the end of the testing procedure, fully vent the media line.
Caution:
First depressurize the system before releasing the connection. The inte-
grated safety system will not let you open the pressure-aided clamping jaws when
the system is pressurized.
Disconnection of a TW156H
Î
Actuate the hand lever (Pos. 2). The clamping jaws open. The connection to the
test piece is released and the connector can be removed by pulling it straight back.
Attention:
In the event that you cannot remove the connector from the test piece:
- Wait a few moments
- Never use excessive force
- Do not use any tools (e.g. hammer)
- Make sure that the connector is depressurized
Disconnection of a TW156V
Î
Actuate the valve button (Pos. 4). The clamping jaws open. The connection to the
test piece is released and the connector can be removed by pulling it straight back.
Attention:
In the event that you cannot remove the connector from the test piece:
- Wait a few moments
- Never use excessive force
- Do not use any tools (e.g. hammer)
- Make sure that the connector is depressurized
Disconnection of a TW156P
Î
Apply pneumatic pilot pressure to the connector. The clamping jaws open. The
connection to the test piece is released and the connector can be removed by pulling it
straight back.
Attention:
In the event that you cannot remove the connector from the test piece:
- Wait a few moments
- Never use excessive force
- Do not use any tools (e.g. hammer)
- Make sure that the connector is depressurized
MD-10021-L51-R2.1.0-03
Page 21
Operating instructions
AE
Содержание TW156
Страница 2: ......