WEG Drive Scan, Руководство пользователя

Страница: 32 / 74

5
CONNECTING A DEVICE TO THE DRIVE SCAN
Motion Fleet Mangement
Cloud
Drive Scan
Ethernet Network
Modbus-TCP protocol
Modbus TCP Ethernet IP
Slave RTU 10 Slave RTU 2 Slave RTU 1
RS-485 Network
Modbus-RTU protocol
Slave TCP 10 Slave TCP 1
Master
CLP
Figure 5.7: Possible connections to the CFW300
WARNING!
The Drive Scan can only be connected to the internet using the Ethernet port GbE0 if it does not
have a proxy.
5.4.4 MONITORING
The Drive Scan continuously monitors the CFW300 parameters specified in Section 5.4.4.1 Attributes Cyclically
Monitored by the CFW300 on page 5-14 .
After a cycle of all these readings, as well as of the other assets connected to the Drive Scan, a new reading cycle
starts automatically.
The parameters read are transformed into attributes, which can be:
Only at initialization;
Last value read;
Average value;
Minimum value;
Maximum value.
Every 5 minutes, the Drive Scan publishes the attributes to the WEG Fleet Management platform.
In case of an internet connection failure, the Drive Scan stores the data for up to 30 days in the internal memory,
publishing it to the MFM when the connection is reestablished.
In case the CFW300 fails, the Drive Scan automatically publishes the parameters specified in Section 5.2.4.2
Attributes Monitored in Events by the CFW11 on page 5-7 asynchronously, that is, without waiting for the normal
cyclical period of publication.
Low Voltage Devices | 5-13