WEG CFW700, Руководство по программированию и устранению неисправностей, Страница: 39 / 223

4
Keypad (HMI)
CFW700 | 4-1
4 KEYPAD (HMI)
The integral keypad can be used to operate and program (view / edit all parameters) of the CFW700 inverter. There
are two operation modes in the keypad: monitoring and programming. The key functions and display indications
of the keypad may change according to the operation mode. The programming mode consists of three levels.
- When in monitoring mode: press this key
to increase the speed.
- When in programming mode, level 1:
press this key to go back to the previous
group.
- When in programming mode, level 2:
press this key to go to the next parameter.
- When in programming mode, level 3:
press this key to increase the parameter
value.
- Press this key to define the motor
rotation.
This option is active when:
P0223 = 2 or 3 in LOC and/or
P0226 = 2 or 3 in REM.
- Press this key to change between
LOCAL and REMOTE mode.
This option is active when:
P0220 = 2 or 3.
BACK
ESC MENU
ENTER
- Press this key to accelerate the motor up to the speed set in P0122. The motor speed is
maintained while the key is pressed. When the key is released the motor decelerates up to its
complete stop.
This function is active when all the following conditions are met:
1. Start/Stop = Stop;
2. General Enable = Active;
3. P0225 = 1 in LOC and/or P0228 = 1 in REM.
- Press this key to decelerate the motor
according to the deceleration ramp time.
This option is active when:
P0224 = 0 in LOC and/or
P0227 = 0 in REM.
- Press this key to accelerate the motor
according to the acceleration ramp time.
This option is active when:
P0224 = 0 in LOC and/or
P0227 = 0 in REM.
- When in monitoring mode: press this key to
enter in the programming mode.
- When in programming mode, level 1: press
this key to select the desired parameter
group – it shows the parameters of the
selected group.
- When in programming mode, level 2: press
this key to show the parameter – it shows
the parameter value for its modification.
- When in programming mode, level 3: press
this key to save the new parameter value – it
returns to level 2 of the programming mode.
- When in monitoring mode: press this key
to decrease the speed.
- When in programming mode, level 1:
press this key to go to the next group.
- When in programming mode, level 2:
press this key to go back to the previous
parameter.
- When in programming mode, level 3: press
this key to decrease the parameter value.
- When in programming mode, level 1:
press this key to go back to the monitoring
mode.
- When in programming mode, level 2:
press this key to go back to the level 1.
- When in programming mode, level 3:
press this key to cancel the new value (the
value will not be saved) and it will return to
level 2 of the programming mode.
Figure 4.1: HMI keys