WEG CFW501, Руководство пользователя, Страница: 36 / 149

CFW501 | 31
Powering up and Startup
E
ng
lis
h
E
ng
lis
h
Seq Indication on the Display / Action Seq Indication on the Display / Action
11 16
„
If necessary, modify the content of “P0402 –
Motor rated rotation”, or press the key
 for
the next parameter.
„
During the Self-Adjustment the HMI will
simultaneously indicate the status of
“RUN”
and
“CONF”
.
12 17
„
If necessary, modify the content of “P0403 –
Motor rated frequency”, or press the Key

for
the next parameter.
„
At the end of the Self-Adjustment, the value
of P0408 automatically returns to “0”, as
well as the Status of
“RUN” and “CONF”
are cleared.
„
Press the key

for the next parameter.
13 18
„
If necessary, modify the content of “P0404 –
Motor rated power”, or press the key

for the
next parameter.
„
The result of Self-Adjustment is the value
in ohms of the motor stator resistance
shown in P0409.
„
This is the last parameter of the Self-
Adjustment of the V V W control mode.
Press the key
 to return to initial
parameter P0202.
14 19
„
If necessary, modify the content of “P0407 –
Motor rated power factor”, or press the key

for the next parameter.
„
To exit the
STARTUP
menu, just press
BACK/ESC.
15 20
„
At this point, the HMI shows the option to do the
self-adjustment. Whenever possible, perform
the self-adjustment. Thus, to activate the self-
adjustment, change the value of P0408 to “1”.
„
Through the keys  and  , select the
desired menu or press the key
BACK/ESC
again to return directly to the monitoring
mode of the HMI.
Figure 5.3 (cont.): Sequence of the Startup group for V VW control