Weco HeSU 5K3-LV HV, Руководство пользователя

Страница: 15 / 69

WeCo 5K3-LV-HV
HeSU 5K3-LV HV Page 15 of 69 V_1.1_21-Nov-2020_LV-HV
1.4 Out of the Box Pre-Operational Check
Attention:
Do not make any connection to the battery until you have thoroughly read and understood this
entire manual.
The Power Button is located on the right side of the battery as shown above. The Power Button is a multi-colored button.
Pressing the Power Button for 2 seconds will initiate the start up process of the battery.
The Power Button will settle as a steady green color if the battery is operating correctly.
If the battery is low on charge the Power Button will display a steady yellow color.
If the Power Button displays a flashing red color there is a fault and you should not attempt any further operation of the
battery and contact WeCo support on
service@weco.uk.com .
There is also an RS232 monitoring Port which will allow you to check all parameters of the battery module. Full instruction
on how to interface to the RS232 Port can be found in this manual.
Attention:
At this stage, after you have determined that the battery is functioning correctly, it is mandatory
to switch the battery off and follow the instructions and guidance in this manual very carefully before attempting any
configuration or connection to the battery module.
To switch the battery of (shutdown the battery) simply press Start/Stop button for 5-seconds and the green LED will go off,
confirming that they battery has shutdown correctly.
Attention:
Read this manual thoroughly and always follow the guidance in this manual before and while
performing any installation procedure.