Weco Discovery 200 S, Инструкция по эксплуатации

Страница: 5 / 14

Discovery 200 S
Cod.006.0001.1320
22/05/2019 v2.8
ENGLISH
5/14
2.3 REAR PANEL
1. Power cable.
Total length (including internal part): 3,5 m
Number and cross section of wires: 4 x 1,5 mm
2
Power plug type: not supplied
2. Welding power source ON/OFF switch.
3. Remote controller connector.
2.4 PREPARING FOR MMA WELDING
1. Set the welding power source ON/OFF switch to “O” (unit de-
energized).
2. Plug the power cable plug into a mains socket outlet.
3. Choose the electrode based on the type of material and thickness
of the workpiece to be welded.
4. Insert the electrode in the electrode holder.
5. Connect the electrode holder cable to the welding socket based on
the polarity requested by the type of electrode used.
6. Connect the plug of the ground clamp to the welding socket on the
basis of the polarity required.
7. Connect the earth clamp to the workpiece being processed.
DANGER!
Electric shock hazard!
Read the warnings highlighted by the following symbols in the
“General prescriptions for use”.
8. Set the welding power source ON/OFF switch to “I” (unit
powered).
9. Select the following welding mode on the user interface: MMA
10. Set the required welding parameter values on the user interface.
When the remote controller [RC] is connected and the relative
locking screw is tightened, welding current can be adjusted using
the remote controller.
The system is ready to start welding.
Preparing for MMA (polarity to basic electrode)
2 3
1