Webfleet LINK 710, Руководство по установке

Страница: 21 / 38

Diagnostics
Monitoring operation
You can monitor the system operation of your LINK 710 by looking at the green
system LED and referring to the table below.
Important: The LINK 710 device must be activated in WEBFLEET.
GREEN LED mode
OFF Unit is in standby mode or is not connected to
power.
▪
Switch on ignition.
▪
Check if the device is properly connected to
power.
OFF and short ON every 3sec Ignition off.
Flashing No operating system and/or no application
available or application failed.
▪
Contact the Webfleet Solutions support team
at
www.webfleet.com/support .
Rapidly flashing (YELLOW LED is
OFF) Reset to factory settings
ON and short OFF every 3sec Ignition on. Application is running, device is not
activated.
▪
Activate device.
ON Application is running, device is activated.
You can monitor the connection of your LINK 710 to the mobile network by looking at
the yellow connection LED and referring to the table below.
YELLOW LED mode
OFF Not connected - No mobile network coverage.
▪
Check if device is connected to power. Switch
on ignition.
▪
Move the vehicle as you may be in a mobile
network dead spot.
21