Weber Summit S-440, Руководство по установке

Страница: 23 / 28

23
WWW.WEBER.COM ®
23
LOCATING YOUR LP TANK ENCLOSURE KIT
When determining a suitable location for your LP Tank Enclosure Kit installation, give
attention to concerns such as proximity to traffi c paths, and keeping any gas supply
lines as short as possible. Never locate the Summit
®
LP Tank Enclosure Kit in a garage,
breezeway, shed, under an unprotected overhang, or other enclosed area. Locate the LP
Tank Enclosure Kit and structure so there is enough room to safely evacuate the area in
case of a fi re.
c.
b. b.
1
1 1
a.
CLEARANCE FROM COMBUSTIBLE SURFACES OR STRUCTURES
WARNING: Clearance from the outside walls of the sides
and back of the LP Tank Enclosure must be a minimum of 24"
(60.96cm) any surface. Refer to “Typical Gas Supply Installation”
before starting installation.
WARNING: The structure, “island” counter tops and adjacent
work areas for the LP Tank Enclosure must be built from
noncombustible materials only.
NOTE: If you have questions on what materials are considered noncombustible, contact
you local building supplier or fi re department.
DANGER
Use of any other hose and regulator assembly could be
dangerous, and may not provide adequate gas supply to
the Summit
®
Built-In gas grill, and could result in a fi re or an
explosion causing serious bodily injury or death and damage
to property.
DANGER
Failure to use the the Summit
®
Built-In Tank Cabinet for a 20
lb cylinder or failure to build a LP cylinder enclosure for a 20
lb cylinder following the requirements for ventilation, cylinder
retention and separation of the LP cylinder from a heat
source, listed in the ANSI Standard for Outdoor Cooking Gas
Appliances, ANSI Z21.58 CSA 1.6, could be dangerous, and
could result in a fi re or an explosion causing serious bodily
injury or death and damage to property.
If you do not follow the DANGER statements exactly, the Warranty on the Summit
®
Built-In gas grill will be voided.
ENCLOSURE CHART
1 24˝ inches (610 mm) Any Surface
a LP Tank Enlosure
b
Any Surface
c Non-Combustible Surface
GENERAL INSTRUCTIONS