BeHear ACCESS User Manual
Page 8 of 39
Product Name: BeHear ACCESS
Product No.: ABH-120
Doc. No. BHAUM202012.31
Basic Operation
Charging the Battery
Charging the battery lasts approximately three hours. We recommend to charge the battery
before using your BeHear ACCESS headset for the first time.
To charge the battery using the cradle:
1.
Plug the larger end of the supplied cable into a standard AC
outlet USB charger adapter, or into the USB port of a
computer, and the cable’s smaller end into the Micro USB
port of the charging cradle.
2.
Place the BeHear ACCESS headset into the cradle. Line up
the embedded magnets in the headset to the contacts in the
charging cradle. The LED will light up when the headset is
positioned properly.
3.
A vibration in the headset indicates that charging has
started. During charging the LED on the neck band will be red, turning green when BeHear
ACCESS is fully charged.
To charge the battery directly by the cable:
1.
Plug the larger end of the supplied cable into a standard
AC outlet USB charger adapter, or into the USB port of a
computer.
2.
Plug the cable’s smaller end into the Micro USB port
located in the BeHear ACCESS neck band.
3.
A vibration in the headset indicates that charging has
started. During charging the LED on the neck band will be
red, turning green when BeHear ACCESS is fully charged.
Note
: The BeHear ACCESS headset should not be used while charging.
Turning the Headset ON and OFF
To turn on BeHear ACCESS:
Press and hold down the Power button
on the neck band
until the unit vibrates and the LED turns light blue.
To turn off BeHear ACCESS:
Press and hold down the Power button
on the neck band
until the unit vibrates and the LED turns light blue.
Note
: Vibration can be disabled by changing a setting in the W&H BeHear application.
Checking the Battery Status
You can view an estimate of the remaining battery charge in either of two ways.
Checking the Battery Level using the Headset
When the device is powered on, quickly press the Power button
on the neck band. The
notification LED flashes for 1-2 seconds indicating battery level, as follows:
LED