Brine Fogging System Type SOLFOG V3
Index: 02
Change date: 19/09/2023
OI No.: BA DW 042-02 Solfog V3 CB36 EN.docx
Page 33 of 65
7.9
Inserting/changing the brine politainer
CAUTION!
Health hazard due to lack of disinfection!
Always carry out a disinfection prior to inserting the politainer!
We urgently recommend that you only use a highly pure, disinfected WDT
brine solution.
To connect a new, unused brine politainer with a 5% brine solution to the dosing line, proceed
as follows:
Fig. 36: Politainer connection
1)
Remove the empty brine politainer from the
console and turn the orifice so it faces up-
wards.
2)
Now pull the connecting plug (Fig. 36,
No. 61) out of the connecting sleeve of the
politainer connection (Fig. 36, No. 61) and
hold the empty brine politainer in your hand
with the lid pointing upwards.
3)
Unscrew the politainer connection from the
empty politainer.
4)
Take a new brine politainer (1 kg or 5 kg),
hold it with the lid pointing upwards and
open the brine politainer’s lid.
The politainer is now open!
5)
Tightly screw the politainer connection onto
the open brine politainer.
6)
Press the entire air out of the politainer, then
insert the connecting plug in the politainer
connection’s connecting sleeve.
The politainer is now closed again!
Fig. 37: Politainer connection with connecting plug
09
Brine politainer
10
Console
61
Connecting plug
62
Politainer connection with con-
necting sleeve canister connection
63
yellow collar ring
7)
Turn the closed politainer 180° upside down
and push it onto the console (Fig. 37, No. 10)
so that the yellow collar ring (Fig. 37, No. 63)
is located below the console. The device is
now ready for use!
61
62
09
10
63
62
61
