Magnetic adjustable force trigger -
Front and back stop position adjustment
The trigger system has four adjustable points, front
stop, back stop, activation point, and magnetic return
strength control.
When adjusting the trigger it is advisable to set both
the front and back stop positions before you proceed
to set the return strength or activation point.
Adjusting the front stop position
•
Insert a 2mm Allen key into the foremost set screw
in the trigger.
•
To move the front stop point
forwards
turn the set
screw
counter clockwise
.
•
To move the front stop point
backwards
turn the
set
screw clockwise
.
Note: It is important to not over adjust the front
stop position set screw in this direction as it will
result in not enough return travel for the trigger
to reset the switch.
Adjusting the back stop position
•
Insert a 2mm Allen key into the set screw located
in the underside of the grip frame
.
•
To move the back stop position
forwards
turn the
set screw
clockwise
.
Note: It is important to not over adjust the back
stop position set screw in this direction as it will
result in not enough travel for a trigger pull to
activate the switch
•
To move the back stop position
backwards
turn
the set screw
counter clockwise
.
Adjusting the return strength
•
Insert a 2mm Allen key into the rearmost set screw
in the trigger.
•
To
increase
the return strength turn the set screw
clock wise
.
•
To
decrease
the return strength turn the set
screw
counter clockwise
.
It is important not to over adjust this portion of
the trigger as it will negate the position of the
front stop set screw for this reason it is advisable
that during the set up of the trigger you should
wind the magnetic return strength adjuster screw
counter clock wise several turns so that it does
not interfere with the adjustment of the front stop
set screw.
Forwards
Backwards
Backwards
Forwards
Decrease
Increase
ADHERE STRICTLY TO THESE
AND ALL OTHER SAFETY
INSTRUCTIONS AND GUIDELINES
· Ensure a barrel blocking device is fitted
to the ANGEL.
· Ensure the hopper is removed from
the ANGEL.
· Ensure that there are no paintballs
in the ANGEL.
· Always remove the first stage regulator and
release all residual gas pressure from the
Angel before disassembly.
· The Angel can hold a small residual gas
charge, typically two shots, with the first stage
regulator removed. Always discharge the Angel
in a safe direction to relieve this residual gas
pressure.
· NEVER adjust your trigger so fine that
accidental discharge can occur due to shock
loads or vibration.
· SHOULD YOU BE UNSURE AT ANY STAGE YOU
MUST SEEK EXPERT ADVICE.
