1
wibenchmfg.com
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Fig. A
Step
2
Step
3
Step
3
V052819 subject to change.
• Screw gun
• 4mm Allen wrench OR
• 4mm Hex bit
• Phillips head screwdriver
Tools Required
Assembly Instructions
Before you begin, please make sure all parts and proper quantities are included. (See Part Identifier Key page) Any parts damaged during shipment must
be reported within 24 hours of receipt. To report information regarding damages or if you have any questions, please call 800.242.2303.
Fig. B
Stand Up desk
Step
4
UNE-T Desk/Table/Workstations
w/ UNE Legs
Step 1:
• Place desk top face down on protected surface so threaded
inserts are facing up.
Step 2:
• Align legs with threaded inserts. Drilling is offset closer to
the back edge.
• Using a 4mm Allen wrench or 4mm Hex bit, secure top with
#10-24x1” joint connector bolts. DO NOT FULLY TIGHTEN
until Step 6.
Step 3:
• Using a 4mm Allen wrench or 4mm Hex bit, attach
connector bar(one piece) to the upper portion of the legs
with 1/4-20x15mm joint connector bolts. The bar should rest
inside the legs. DO NOT FULLY TIGHTEN until Step 6.
(Fig A)
• If you have an adjustable connector bar, use #12 star
washers and M6-1x14 screws to fasten the two connector
bars together. DO NOT FULLY TIGHTEN until Step 6.
(Fig B)
Step 4:
• If assembling a Stand Up desk, use a 4mm Allen wrench or
4mm Hex bit to attach the foot rest bar to lower portion of
the legs using #12 star washers and M6 1x14 screws. DO
NOT FULLY TIGHTEN until Step 6.