1
wibenchmfg.com
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Tomah
Assembly Instructions
Before you begin, please make sure all parts and proper quantities are included. (See Part Identifier Key) Any parts damaged during shipment must be
reported within 24 hours of receipt. To report information regarding damages or if you have any questions, please call 800.242.2303.
Step 1:
• Place one of the base cabinets upside down on a
protected flat surface with it’s sub-bottom facing up.
(
Upon installer’s discretion, remove doors, shelving
& drawers before turning cabinets over to lessen the
weight of the cabinets.
)
• Repeat above step for the other base cabinet but when
you’re placing it down on the protected surface, align the
pre-drilled holes on the side of both cabinets with each
other.
Step 2:
• With cabinets aligned together, place the 1/4-20 x 30mm
joint connector bolt w/ loctite through pre-drilled hole
on the inside of one of the cabinets making sure bolt is
pushed as far as it can go.
• While holding the joint connector bolt flush to the
cabinet, take a 1/4-20x17mm joint connector nut and
attach it to the end of the bolt (located in other base
cabinet) turing it clockwise until it’s completely on. Use
a 4mm Allen wrench or 4mm Hex bit and a screw gun to
tighten as needed.
• Repeat
Step 2
with the remaing bolts and connector nuts.
There will be a total of 4 each. (See
Step 1
image for the
location of the pre-drilled pilot holes.)
Step 3:
• With both cabinets attached together, take caster base
and center it on the two cabinets with threaded inserts
facing up.
• Using #2 square bit, attach caster base to the base
cabinets using #10 11/2” square-drive flat head screws. (See
image to the right; pre-drilled pilot holes are marked in
red as an example for assembly instructions ONLY.)
V042419 subject to change.
Step
1
Step
2
Step
3
Images of these base
cabinets are shown upside
down in
Steps 1-5.
