1
wibenchmfg.com
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Specifications are subject to change. Product
images are for illustrative purposes only and may
differ from the actual product.
LOB3092-ADJ-RR6
Before you begin, please make sure all parts and proper quantities are included. (See Part Identifier Key) Any parts damaged during shipment must be reported
within 24 hours of receipt. To report information regarding damages or if you have any questions, please call 800.242.2303.
LOBO Ingenuity Table
Assembly Instructions
Step 1:
• Place top face down on protected flat surface so threaded
inserts are facing up.
Step 2:
• Place LOBO frame tabs down on top of the top and align with
pre-drilled pilot holes.
Step 3:
• Starting at one corner, place the 5/16” bolt that is welded to leg
through corner support brace of frame. Repeat for remaining
legs.
Step 4:
• Using a # S2 square bit, secure the leg plate to the top with
#10 x 3/4” square pan screws. Repeat for each leg plate.
Step 5:
• Place the 5/16” lock washer and 5/16” hex nut onto the leg bolt
and tighten with 1/2” wrench. Repeat on remaining legs.
• Adjust the leg to desired height.
Step 6:
• Using a # S2 square bit, secure frame to top with #10 x 3/4”
square pan screws. One screw per tab.
Step 7:
• With someone’s help, turn table upright.
Step 8:
• Align pre-drilled holes in one of the long laminate rails with
the threaded inserts in the side of the top.
• Using a 1/4-20 x 40mm joint connector bolt, insert the bolt
through the pre-drilled hole in the rail into the threaded
insert of the top. Use a 4mm Allen wrench or a 4mm hex bit
and a screw gun to fasten bolt into place.
• After the first bolt is fastened, proceed attaching the
remaining bolts in the long rail.
• Repeat
Step 8
for the remaining three rails.
V022821 subject to change.
Step
4
Step
6
Step
5
Step
3
Step
8
