1
wibenchmfg.com
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Specifications are subject to change. Product
images are for illustrative purposes only and may
differ from the actual product.
Before you begin, please make sure all parts and proper quantities are included. (See Part Identifier Key) Any parts damaged during shipment must be reported
within 24 hours of receipt. To report information regarding damages or if you have any questions, please call 800.242.2303.
EPIC Tables
Laminate/Phenolic/Butcherblock/Stainless Steel Tops
Assembly Instructions
Step 1:
• Place EPIC frame leg with plate facing down on a flat surface.
Step 2:
• Align holes in the end plate of the cross bar with the frame.
Make sure the tabs on the cross bar are facing down.
• Connect cross bar to the frame using 1/4”-20 x 50mm joint
connector bolts and 1/4”-20 joint connector nuts.
• Use a screw gun and a 4mm Hex bit to tighten the joint
connector bolts to the nut. We suggest using a 4mm Hex
wrench to hold the nut in place while tightening the bolt.
• Repeat for other frame leg.
Step 3:
• Place the EPIC top face down on a protected flat surface
so threaded inserts(marked in green) and pre-drilled pilot
holes(marked in yellow) are facing up.
Step 4:
• Place frame leg/cross bar on the top and align with threaded
inserts & pre-drilled pilot holes.
• Using a screw gun and a 4mm Hex bit, secure both frame legs
to top with 1/4”-20 x 15mm joint connector bolts. Use eight
bolts for each frame leg.
Step 5:
• Using a screw gun and a # S2 square bit, secure cross bar to
top with #10 x 3/4” square pan screws. Use one screw per tab
with a total of six screws being used (3 per side).
Step 6:
• Before placing caster in the bottom of the frame leg, lock the
caster by pushing down on the brake lever.
• Twist the stem of the caster into the hole on the bottom of
the leg frame. Applying thread locking adhesive can help
prevent unexpected loosening of the caster.
• Use 3/4” wrench to tighten 3/4” nut on stem of caster.
• Repeat for remaining casters.
Step 7:
• With someone’s help, turn table upright.
Tools Required
• Screw gun
• # S2 square bit
• 4mm Hex bit
• 4mm Hex wrench
• 3/4” Wrench
• Thread Locking
Adhesive (optional)
Step
6
Step
4
Step
7
EPIC frame leg
Step
1
Step
2
Cross bar
Tab
Joint connector bolt
Joint connector nut
Step
5
Step
3
V012821 subject to change.
