Waycon LRW2 Series Скачать руководство пользователя страница 1

NOTES

WayCon Positionsmesstechnik GmbH
Mehlbeerenstrasse 4
82024 Taufkirchen / Germany

This is to certify that the products

Classification

Linearpotentiometer

Series

LRW2, LRW3

fulfill the current request of the following EC-directives:
EMV-directive

2004/108/CE

applied harmonized standards:
EN 61000-6-2:2005, EN 61000-6-4:2007, EN 61326-1:2006

The declaration of conformity loses its validity if the product is misused or modified without proper 
authorisation.

Taufkirchen, 13.03.2013

Andreas Täger
CEO

DECLARATION OF EC-CONFORMITY

All the data reported in this brochure and the data sheet, like linearity, lifetime, temperature coefficient are 
valid for a sensor utilization as a ratiometric device with a max current across the cursor Ic ≤ 0.1 mA.
Do NOT use the position sensor as variable resistance!
When calibrating the transducer, be careful to set the stroke so that the output does not drop below 1% or 
rise above 99% of the voltage level.

MAINTENANCE

The sensors are maintenance free. It is not necessary to lubricate the moving parts.

INSTALLATION GUIDE

Linear Potentiometer Series LRW2, LRW3

For further information please see the data sheet at www.waycon.biz/products/linear-potentiometers/

FIRST STEPS

MOUNTING THE SENSOR

ELECTRICAL CONNECTION

WayCon Positionsmesstechnik GmbH would like to thank you for the trust you have placed in us and our 
products.  This  manual  will  make  you  familiar  with  the  installation  and  operation  of  our  linear 
potentiometers. Please read this manual carefully before initial operation!
Unpacking and checking:
Carefully lift the device out of the box by grabbing the housing. After unpacking the device, check it for 
any  visible  damage  as  a  result  of  rough  handling  during  the  shipment.  Check  the  delivery  for 
completeness.
If necessary consult the transportation company, or contact WayCon directly for further assistance.

Groove mounting with clamps (included in delivery)

Mounting with 
brackets 
PKIT006 
(accessory)

 

3  (V+)
2  (cursor)

1  (V-)

Sensor is to be used as voltage divider, using a maximum cursor current of Ic ≤ 0.1 µA  (do NOT use the 
sensor as variable resistance!). Please pay attention to the notes on the last page. 

Signal

LRW2-C/LRW3-C

LRW2-F/LRW3-F

V-

PIN 1

blue

cursor

PIN 2

y ellow

V+

PIN 3

brown

Отзывы: