WIFI-LPT100-B User Manual
6
/
60
1.2 Network Connection
The following is the WIFI-LPT100-B module example, except SSID, other
modules are the same to WIFI-LPT100. Open Wi-Fi, search network, as shown in
below, WIFI-LPT100-B is the default network name (SSID) of the module.
Join the network, choose to automatically obtain IP. WIFI module supports
DHCP Server feature and it is enabled by default.
Now, Link led of WIFI-LPT100-B Evaluation Board is lighting.
1.3 Communication Test
Module
’
s default setting:
➢
SSID:
WIFI-LPT100-B;
➢
Encryption mode:
open, none;
➢
UART:
115200, 8, 1, None;
➢
Network parameters:
TCP, Server, 8899, 10.10.100.254
➢
IP:
DHCP,0.0.0.0,0.0.0.0,0.0.0.0
We just need to follow the parameters of the corresponding set of network
communication parameters, you can make serial <--> WIFI communication, the steps
are as follows:
1.
Open test software TCP232;
2.
COM settings area (left):
Choose COM port which is connected the module, there is COM4, choose
baud rate to 115200, this is the default baud rate of WIFI module, Click
Open COM port.
3.
Net Settings area (right):
Choose TCP client mode, Server IP write 10.10.100.254, it is the WIFI
default IP address, Server port to 8899. It is the default Port the WIFI
module listen, click Connect to link module.
Figure 2 WIFI Search
Figure 3 WIFI Connection