WaveRider MMT9000, Руководство по установке

Страница: 24 / 43

2: Installation
APCD-WM001-1.0 12
This is the recommended approach. If for some reason this is not acceptable, then the
MMT9000 must be configured with its radio frequency.
The easiest installation uses the MMT9000 factory defaults, so that the modem will gets all its
IP address information from DHCP and its RF Frequency from the Nomadic Base Station
Discovery feature.
Other useful information for the installer includes:
• The IP address of a site that accepts pings as well as the name of a site that accepts
pings, for testing the data link.
• Whether modem is being connected directly to end-user PC or via an Ethernet switch
or IP router. In the latter cases, the installer must provide a straight-through Ethernet
cable to connect the modem to the switch/router.
2.2.2 Verifying the MMT9000 Components
See MMT9000 - MobileWAN Mobile Terminal on page 4 for more information on the MMT9000
kit. Verify that the MMT9000 kit is complete with:
• MMT9000 modem
• Power cable assembly
• Fuse assembly
In addition to the modem itself, verify that the antenna selected for the installation is complete,
including:
• Antenna
• Antenna Mounting hardware, be it a magnetic or vehicle mount for the mobile
antennas or clamping hardware for the panel antenna
Equipment that is needed but not provided since it will unique to each installation, includes:
• Ethernet cable - this will be a straight-through or cross-over cable depending on
whether the end-user’s PC is connected to a switch or directly to the MMT9000.
• Mounting bolts, washers and nuts - for attaching the MMT9000 rail to an equipment
tray, directly to the vehicle or to some other attachment point.
2.2.3 End-Users PC
Ensure that the end-user PC is equipped with an Ethernet interface.