WaveRider MMT9000, Руководство по установке

Страница: 19 / 43

1: Introduction
APCD-WM001-1.0 7
1.3.2 MMT9000 Suite of Antennas
Only the following antennas are approved by FCC to be used with the MMT9000. All of these
antennas and their mounting assemblies can be purchased from WaveRider.
The end user must position the antenna correctly to receive an adequate signal level.This is
especially true of the panel antenna which is a directional antenna. The Radio LED on the
MMT9000, described in
section 1.3.1 , MMT9000 Modem - External Indicators and
Connectors, or the Setup menu, described in Setup Menu on page 21, can be used to help
with the alignment..
WARNING!
To comply with FCC RF exposure limits, the MMT9000 mobile
antennas must be mounted to provide a separation distance
of 20cm (8 inches) or more from all persons. The MMT9000
panel antenna must be mounted to provide a separation
distance of 30cm (12 inches) or more from all persons. The
distance is measured from the nearest point of the antenna to
the human body.
MMT9000
Mobile Antennas
The MMT9000 is designed for use with variety of mobile whip antennas. The following mobile
antennas has been certified to be used with MMT9000:
Table 3 MMT9000 Mobile Antennas
NOTE: The mobile antennas must be mounted on a metal surface at
least 1 Meter diameter for best performance.
Maker Model Gain Mount
Pacific Wireless RFLMA9 7 dBi RFLMM-110
MAXRAD MUF9035NGP(S) 5 dBi BGMML or BMAML
MAXRAD MUF9025NGP(S) 5 dBi BGMML or BMAML
MAXRAD MUF9003NGP(S) 3 dBi BGMML or BMAML
MAXRAD MUF9035NGP(S) 3 dBi BGMML or BMAML
MAXRAD MUF9000NGP(S) Unity BGMML or BMAML