American Wavefrontier Corp
100 Pacifica Suite 260
Irvine, CA 92618 - 1 -
Thanks for choosing Toroidal. This file is developed to assist you in assembling and aligning
Toroidal Dish.
With Toroidal dish, you are aiming for more than 1 satellite and therefore this process will
require more time for assembling and aligning the dish. If you follow this process carefully, you
will cut down the installation time and achieve optimal signal strength for all satellites you are
aiming for.
TIP: Assemble and align Toroidal at ground level with
small TV and receiver right next to you. This will
save you a tremendous time. (If you have a sat
finder equipment, maybe not.) After the alignment,
you can put the assembled dish on your roof and
adjust azimuth only, take a minute and reducing the
risk and sweat!
You will find two pouches including bolts and nuts. One pouch is to assemble the dish and the
other is for the pole mount. (Pole mount assembly is not illustrated here. Use the diagram in
the box.)
•
Print out (if you have not) the part list. Sort and group the bolts and nuts according to
the part list. This will save a lot of time and confusion.
•
You will need Phillips Screw Driver and 10, 11, 12, 13 mm Wrenches for the assembly.
•
Begin the process on flat surface.
•
Make sure your location is not blocked from building or a huge tree. Remember you are
installing more than one satellite, thus you need a wider clear view of the sky.
Now let’s go ahead and start assembling.
Before You Begin
Assembling Toroidal
