WM_PRJ_Q2400_PTS_005 -007
18th January 2006
Confidential©
All rights reserved
Page:
44
/
51
This document is the sole and exclusive property of WAVECOM. Not to be
distributed or divulged without prior written agreement.
6 EMC recommendations
The EMC tests have to be performed as soon as possible on the application to
detect any possible problem.
When designing, special attention should be paid to:
•
Possible spurious emission radiated by the application to the RF receiver
in the receiver band
•
ESD protection on SIM (if accessible from outside), serial link, etc. Refer to
section 2.2.6 SIM interface.
•
Length of the SIM interface lines (preferably <10cm)
•
EMC protection on audio input/output (filters against 900 MHz emissions),
refer to section 2.3.2 audio interface.
•
Bias of the Microphone inputs, refer to section 2.3.2 audio interface.
•
Ground plane : WAVECOM recommends to have a common ground plane
for analog / digital / RF grounds.
•
Metallic case or plastic casing with conductive paint are recommended
Note :
The module does not include any protection against overvoltage.