Element
Section 10: Edge SC Controller Operation
L-OMM-0003_A
• 10/8/2021 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page
92
of
157
10.4.7 Software Update
10.4.7.1
Installing Updates
To update software on the Element click
Install Update
and follow the prompts. Perform a
cloud update if the unit is cloud-commissioned, or use a file loaded onto a USB memory stick.
The current system can be backed up onto a USB memory stick or restored from a previous
backup. This is typically only necessary for units that are not cloud-commissioned as the data is
already backed up in the secure Azure cloud servers while connected to the network.
Previous backups and versions of EdgeSC firmware can be managed from this screen.
Figure 73 - Unit Software
10.4.7.2
System Backup
To perform a system backup, plug in the USB memory stick. Select
Backup
in the System
Backup menu. Begin the Back Up process by selecting
Start Backup
on each menu prompt.
10.4.7.3
Presence Sensor and Screen Dimming
The screen will dim approximately 5 minutes after the Element does not detect a person in front
of it. The screen may not dim because either an alert needs to be reviewed or something has
changed in the surrounding environment.
10.5 BAS Modbus Points
Modbus can be utilized to connect to a remote BAS or BMS in order to read (not write to)
Element data.
