ProtoNode FPC-N34 & FPC-N35 User Manual
APPENDIX H: FAULT CODES FOR MODULEX E8 CONTROLLER
OMM-0150_B
• 5/20/2021 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page
125
of
140
APPENDIX H: BCM AND BMM FAULT CODES FOR MODULEX E8
CONTROLLER
Appendix H-1: BCM and BMM Fault Code Conversion Table
Table H-1, below, shows how to interpret the displayed fault code in the E8 Controller display,
while Table H-2, on the next page, shows a description of the fault and troubleshooting tips
associated with the BMMs. Table H-3, following, is for BCM faults.
In order to derive the correct error code from what is shown in the E8 Controller display, use
Table H-1, below, to determine the working error code. To use the table, identify the displayed
number from the first column, identify the affected module from the second column, apply the
formula from the third column, and identify the Error Table to reference from the fourth column.
Table H-1: BCM and BMM Fault Code Conversion Table
Observed Code
Observed
Code
Code to Look Up in
Table
Code =
0
N/A
No Fault
-
Code between
1
and
255
BMM #0 Fault
Look up code
F-2
Code between
256
and
511
BMM #1 Fault
Subtract
256
from reading
F-2
Code between
512
and
767
BMM #2 Fault
Subtract
512
from reading
F-2
Code between
768
and
1023
BMM #3 Fault
Subtract
768
from reading
F-2
Code between
1024
and
1279
BMM #4 Fault
Subtract
1024
from reading
F-2
Code between
1280
and
1535
BMM #5 Fault
Subtract
1280
from reading
F-2
Code between
1536
and
1791
BMM #6 Fault
Subtract
1536
from reading
F-2
Code between
1792
and
2047
BMM #7 Fault
Subtract
1792
from reading
F-2
Code between
2048
and
65279
N/A
Invalid Codes
-
Code above
65280
BCM Fault
Subtract
65280
from reading
F-2
Example:
Based on the above, a code reading of “261” means the fault occurred on BMM #1.
The fault code is (261
– 256 = ) 5. An Error Code of 5 from the BMM Fault Codes
table means “Flame Loss During Run”.
