All of the controls for the sensor are located on the sides of the sensor.
1.
Time Delay
—is denoted by “Time” and is adjustable from 15 seconds to 15
minutes. This adjustment determines the length of time the lights stay on
after no motion has been detected.
2.
Sensitivity Adjustment
—is denoted by “Sense” and is adjustable from zero
to 10. The zero setting is OFF and the 10 setting is the most sensitive.
3.
Bypass Setting
—should a sensor fail, it can be overridden and set to a
permanent ON position through the installation of the override pin provided
with the sensor.
4.
LED Indicator
—the LED will blink each time the unit triggers.
UNIT CONTROLS
SENSOR
PLACEMENT
When positioning the
sensor make sure the
receiver is aimed
away from nearest
wall and toward the
area to be covered.
On the
W-500A
model, there is only
one receiver, which is
on the opposite side
of the by-pass pin. Always make sure this receiver is pointed toward activity
area. The
W-1000
and
W-2000
both have dual receivers. Point these toward
the activity area.
For enclosed spaces, place
sensors as shown above.
CORRECT LOCATION
Sensors placed as shown above may see
out the door and cause false triggers.
INCORRECT LOCATION
