Document #10-32813 Rev A; June 07, 2019
Page
64
of 69
Appendix 1 RMA PLUS Setup Keys Reference
This is an alphabetical reference of the setup keys used in the configuration files that enable and configure product fea-
tures for the RMA PLUS. For complete details about configuring the various features, refer to each individual feature.
The key is not case sensitive, but must match the key string implemented in the product.
Key
Value
Feature Definition
DataLog nor:\Gateway\DataLog.csv
Data log-
ging
Applies only to model number RMAP-XX
D
X-XXXX.
This provides the full file name / path where the data log configuration file lives. Elements in
this file will be written to a log file at a pre-defined interval.
Setup Key: Data Log
Key
Value
Feature
Definition
Discover 0 = dis-
abled
1 =
enabled
intermodule bus
over Ethernet dis-
covery
This key is enabled by default. It enables or disables the intermodule bus over Eth-
ernet discovery feature. When discovery is disabled (the value is set to 0), software
tools will not discover the device.
This record is not in the setup.csv file by default. To use this feature, add this key and
value to the setup.csv file.
Setup Key: Discover
Key
Value
Feature Definition
EventLog ram:\EventLog.txt
Event Log
Full file name / path where the event log will be written. If there are issues with the
product, you may be asked to provide this file or move it to one of the non-volatile
volumes (“sd:” or “nor:”). The (*.txt) extension is recommended.
Setup Key: Event Log
Key
Value
Feature Definition
HTTPs nor:\Gateway\Https.csv
HTTP
Server
Full file name / path of the HTTP server configuration file. Elements in this file are
used to display system parameters on custom web pages. To use this feature,
add this record to the setup file.
Setup Key: HTTPs
Key
Value
Feature Definition
LogKeepDays integer
1 - 365
10 by
default
Data log-
ging
This key only applies if the model number is RMAP-XX
D
X-XXXX.
This key defines the number of log files (days) to keep. It is interpreted as an integer with a range of 1 –
365 days. A value greater than 365 days will disable this feature. The default value is ten days.
Setup Key: LogKeepDays
