Watkiss Automation BookMaster, Руководство по обслуживанию

Страница: 95 / 128

Machine Inspections • TrimMaster Pro - After-Build Inspection
Watkiss BookMaster Service Manual - Issue 1 - 04/12/00
89
5.8 TrimMaster Pro - After-Build Inspection
TrimMaster Pro Serial Number :
SECTION 1 - VISUAL CHECKS CHECKED COMMENTS / NOTES PASSED
1. Check painted surfaces
2. Check guards
SECTION 2 - ACCESSORIES CHECKED COMMENTS / NOTES PASSED
1. Check that a trim bin is installed
SECTION 3 - LABELS CHECKED COMMENTS / NOTES PASSED
1. Check that all the labels are fitted
SECTION 4 - PRE-RUN SETTING UP CHECKED COMMENTS / NOTES PASSED
1. Check all controls and settings
2. Check voltage settings
SECTION 5 - RUNNING CHECKS CHECKED COMMENTS / NOTES PASSED
1. Hand-feed 2, 4, 8, 16 and 20 sheets of A4
into machine and check booklets
2. Check trim length microswitch is correctly
calibrated to the control panel, adjust
microswitch if required
3. Run the system under the Vario, using as
many bins as possible. Use all functions
on menu & check TrimMaster responds
accordingly, e.g. trim length, no trim
4. Check that the Outfeed Conveyor
functions correctly
5. Repeat stages 1. and 3., using the edge
staple mode
SECTION 6 - SAFETY SWITCHES CHECKED COMMENTS / NOTES PASSED
1. Check the trim lid switch
SECTION 7 - PRE-DELIVERY CHECKS CHECKED COMMENTS / NOTES PASSED
1. Check that the machine is clean
2. Record the machine’s serial no.
3. Re-check all painted surfaces
Checks completed by : Date :
Table 5:8 TrimMaster Pro - After-Build Inspection