Watkiss Automation BookMaster, Руководство по обслуживанию

Страница: 86 / 128

80
Watkiss BookMaster Service Manual - Issue 1 - 04/12/00
Machine Inspections • BookMaster Standard - After-Build Inspection
5.5 BookMaster Standard - After-Build Inspection
BookMaster Serial Number :
SECTION 1 - VISUAL CHECKS CHECKED COMMENTS / NOTES PASSED
1. Check painted surfaces
2. Check position of staple heads
3. Check alignment of clinchers and lock
4. Check guards
SECTION 2 - PRE-RUN SETTING UP CHECKED COMMENTS / NOTES PASSED
1. Check all controls and settings
2. Check all wiring and connections
3. Check voltage settings
4. Check which software is fitted to both the
BookMaster and the Vario; update if required
5. Test the infeed sensor
6. Hand-feed sets of 4 sheets of A4; check
booklets and adjust as necessary
7. Check outfeed conveyor is working (if fitted)
SECTION 3 - RUNNING CHECKS CHECKED COMMENTS / NOTES PASSED
1. Run the system under the Vario with as many
bins as possible; check booklets and adjust
as necessary
2. Hand-feed 2, 4, 8, 16 and 20 sheets of A4 into
machine and check booklets
3. Repeat steps 1. and 2., but in edge staple
mode
4. Check safety switches
SECTION 4 - LABELS CHECKED COMMENTS / NOTES PASSED
1. Check that all the labels are fitted
SECTION 5 - PRE-DELIVERY CHECKS CHECKED COMMENTS / NOTES PASSED
1. Check that the machine is clean
2. Record serial no.’s of PCBs, staple heads and
machine
3. Re-check all painted surfaces
Checks completed by : Date :
Table 5:5 BookMaster Standard - After-Build Inspection