3 - 2
Watkiss Automatic SpineMaster Service Manual - Edited 17/06/04
Quality RAPS
•
Spine Forming RAP
3.1 Spine Forming RAP
Spine Formations
Inspect formed booklets and adjust the ‘Book Thickness Adustment’ control
(see 1.8.3) and/or the ‘Operating Mode’ control as required (see 1.8.4).
If the spine is well formed at only one end of the booklet, Double Pass Mode
should be used. Some stocks may require Double Pass Mode to achieve an
even result.
If booklet spines are being formed unevenly, check that the Stop is parallel
with the Clamp, and that the minimum depth is correctly set (see 4.7.7).
✔
Correct: This is how a well formed
spine should look.
✖
Incorrect: The spine has not been
formed sufficiently.
Increase the Book Thickness Adjust-
ment and/or use Double Pass Mode
Incorrect: The spine has been over-
formed resulting in damage or creas-
ing on the cover.
Decrease the Book Thickness Adjust-
ment and/or use Single Pass Mode.
✖
Содержание Automatic SpineMaster
