TRANSFORMER
BOARD
GROUNDING BAR
RELAY
1. DEVICE IDENTIFICATION
• First identify which device is connected to which relay. For the purposes of this tutorial the far left relay will be used for the
Filter Pump, as it is the most common application.
• Each successive relay from the left is:
- Filter Pump
If using Filter Pump other than Waterway, High Voltage must be wired directly from Breaker. Pump will be controlled with
Low Voltage communication cable.
- Aux 1 (Water Feature, etc...)
- Aux 2 (Spa pump, etc…)
- Aux 3 (Pool Light, etc…)
- Aux 4 (Spa Light, etc...)
- Aux 5 (Cleaner, etc..)
• This order or device is not required, it is only for reference. Any Auxiliary device can be on any relay except for Relay 1 as long
as the OASIS is programmed accordingly.
Once each device and its corresponding Relay are identified, begin programming the OASIS. Please refer to the “OASIS
Instruction Manual” for installation guidance.
NOTE:
Heaters are controlled with Low Voltage communication.
2. PROGRAM OASIS:
• Press Menu , and Down to highlight ‘Installer Setup’.
• With ‘Installer Setup’ highlighted press; Menu , then Up , then
Down .
• Press Right , at ‘Assign Output’.
1