2200 East Sturgis Road, Oxnard, CA 93030 • Ph. (805) 981-0262 • Fax (805) 981-9403
www.waterwayplastics.com • [email protected]
810-0180.0109
© 2009 Waterway Plastics
2 ½" POLY STORM GUNITE JET (210-3710)
INSTALLATION INSTRUCTIONS AND PRESSURE TESTING
1. Hang Poly Storm Gunite Jet Body with ties through preset holes onto steel rebar.
3. Glue 2 ½" cap onto end of pipe for pressure test before guniting.
5. Cut a piece of 1" PVC pipe a couple of inches longer than the 2 ½" pipe and glue the threaded
retainer ring to it.
7. Unscrew 1" PVC Pipe from the body and cut 4 1⁄8" inward from the mark towards retainer ring,
then glue wallfitting to 1" PVC pipe.
8. Wrap Teflon tape onto the threaded retainer ring and thread the 1" PVC pipe back into the
body using a Poly Storm Gunite Wrench (218-1790), making sure of a snug fit.
6. Insert 1" PVC pipe through the niche and up to the Poly Storm Gunite jet body and thread in
until it bottoms out. Make a mark on the 1" PVC pipe flush with the gunite niche.
2. Estimate needed length of 2 ½" PVC pipe by thickness of wall. Cut 2 ½" PVC pipe at least 4"
longer than estimated finish length. Then glue 2 ½" PVC pipe to body.
Ties
Steel Rebar
Body
(211-3060)
2" Water
Estimated Length
8" min. from back of jet body
4"
2 ½" Cap
4. While guniting, scoop out gunite around the 2 ½" PVC pipe, allowing for the plaster niche
(425-5030) (not included). Before plastering, cut the 2 ½" pipe so that the plastic niche will
fit flush with the finished wall. Glue the plaster niche onto the pipe, then cover the niche with
tape for plastering.
Gunite Wall
Chip out wall
around pipe
2 ½" PVC Pipe
SCH 40
Gunite Poly Jet Niche
(425-5030)
Retainer Ring
(219-1060)
Wall
Mark 1" PVC pipe
flush with wall
Retainer Ring
(219-1060)
Retainer O-Ring
(805-0215)
Wallfitting
(215-1090)
4 1⁄8"
Make
cut here
Mark line
from step 5
Wall
Retainer Ring
(219-1060)
Wallfitting
Assembly
Poly Storm Jet Wrench
(218-1790)
Wrap Teflon Tape
1
5
6
7
8
2
3
4
